Figure 3-11 3.2.2 PIN method There are two ways to configure the WPS by PIN method: Enter the PIN from your Router or AP device.No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. National Restrictions This device is intended for home and office use in all EU countries (and other countries following the EU directive 19995EC) without any limitation except for the countries mentioned below: Country. This equipment should be installed and operated with minimum distance 20cm between the radiator your body. If any of the above items are damaged or missing, please contact your distributor. Note: The adapter mentioned in this User Guide stands for TL-WN725N 150Mbps Wireless N Nano USB Adapter without any explanations. ![]() Use My Tl-Wn725N For An Access Point On Driver Has BeenThe driver has been installed but no data is being transmitted or Flashing Slowly received. ![]() Insert the Resource CD into your CD-ROM drive and then select model TL-WN725N on the window that pops up (as shown in the below Figure 2-3). There will be a menu including: Install DriverUtility and User Guide. It is recommended to select Install TP-LINK Wireless Configuration Utility and Driver. Use My Tl-Wn725N For An Access Point On Software Or YouFigure 2-6 Click Change to specify the destination location for the software or you can leave it default. Figure 2-10 After installation, the utility configuration page will automatically pop up as shown in the following figure and the icon will appear in your system tray. ![]() Use My Tl-Wn725N For An Access Point On Password In TheWireless network of WPAWPA2-PSK If you selected a wireless network of the security type WPAWPA2-PSK, you will be prompted to enter the password in the security key field, as shown in Figure 3-3. With Password as your authentication, you should enter the right user name and password in the corresponding field, as shown in Figure 3-7. Figure 3-6 You have now successfully connected to your network. Figure 3-7 To view more information about the network currently connected, click Status in the tools. If your wireless Router supports WPS or QSS (Quick Security Setup), you can establish a wireless connection between wireless card and Router using either Push Button Configuration (PBC) method or PIN method. Select Push the button on my access point or wireless Router and then click Connect. Figure 3-9 The adapter will be connecting to the target network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |